Soul Performance Non-Valved Exhaust System (No Anti-Drone Tubes) - Porsche 991.2 Carrera (without PSE / Base Model) 17-19

Description

*Base models must use OEM tips if running factory cats.

The non-PSE equipped 991.2 exhaust system is far too quiet from the factory. The Soul Performance Products rear exhaust increases much needed tone while minimizing drone with anti-drone tubes for a more invigorating driving experience.

- Fits base Porsche 991.2 Carrera vehicles without Porsche Sport Exhaust / PSE (2017-2019)
- Weighs .65 lbs / .3 kg less than factory exhaust components (16.7 lbs w/ antidrone tubes vs 17.35 lbs factory)
- Designed and built in-house at our Willow Grove, PA facility
- All Soul Performance Products exhaust components are backed by a renowned Lifetime Warranty for both street and track use

DEVELOPMENT AND TESTING
We set out to craft a rear exhaust that was simple, light, and as aggressive as possible while retaining drivability. The 991.2 non-PSE equipped cars are prone to droning in the 1,800-2,200 RPM range with aftermarket exhausts - the primary factor that we based our system around. We tested numerous variants incorporating resonators, helmholtz resonators / anti-drone tubes, straight pipes, and a basic x-pipe to hone in on the best possible solution. Testing was done with and without our Sport Catalytic Converters as they are a very common modification. Resonators reduced the overall engine tone and volume and did not have enough of an impact on the drone. Helmholtz resonators (also known as anti-drone tubes) are an effective way to reduce undesirable frequencies when engineered and utilized correctly. Our final design has proven to offer the very best results on this application and achieved our high standards for sound quality and drivability. Looking for the most aggressive sound and lightest weight? We also offer the system without anti-drone tubes for a lighter, more cost effective solution - the exterior volume and tone is the same minus the reduction in drone.

CONSTRUCTION
Each exhaust is hand made out of mandrel bent, thick wall .065" T304L stainless steel, rigorously quality checked in-house. Back purged TIG welding ensures proper weld penetration and longevity.

BOLT ON AND GO
Each product is tested in a fixture to ensure perfect fitment then foam packed to ensure it arrives in perfect condition. Thorough installation instructions are included in the box for a straightforward install that can be performed by most DIY enthusiasts.